|
Exclusive
North
American Distributor
International
Water Treatment NA
2607 Bridgeport Way West,
Ste. 1J
University Place, WA 98466
Tel
253.566.1438
FAX 253.566.1512
Email - Information
& Sales
Email - Technical
Support
|
| |
Elysator
Type 260
|
| Capacity |
| Elysator
Type |
T260 |
| Start up
L/min |
50 |
| Norm
L/min |
20 |
| Volume m³ |
70
m³ |
| Joining |
1
½» |
| Total
Height |
1500mm |
| Diameter |
800mm |
| Weight |
|
| Freight
weight |
|
|
|
The
Elysator to be mounted as shown on the illustration (Ill.
260a), in a by-pass position preferably over the main pumps,
discharge line to be connected to the lower half (inlet) and
suction line to upper half outlet. The inlet/outlet not in use
is to be plugged (only on type15- 100). The water flow to be
adjusted with the regulating valve after the flowmeter, while
the ball valve on the inlet remains full open. Pipes to be of
mild steel (galvanized pipes is not permitted) and with
diameter not less than 1” Elysator to be installed as close
as possible to the connection point, and as low as possible in
the system. Remember drain. Be sure that the when mounting the
Elysator to the deck, there is sufficient height above the
Elysator. (only for type 15-260) So there is space to lift up
the flange with the anode for cleaning overhaul etc. |
|
| Type
260 |
| |
Dim |
Qt.. |
Art.no |
| Elysator |
T260 |
1 |
100014 |
| Flowmeter |
11/4”
Vertical |
1 |
100092 |
| Airvent |
LK
3/8” |
|
|
| w/
ballvalve |
|
1 |
100000 |
| Reg.valve |
11/4” |
1 |
100118 |
| Ballvalve |
11/4” |
2 |
100103 |
| Drainvalve |
11/2” |
1 |
100123 |
| Indicator |
0
– 100mA, analog |
1 |
100078 |
| Anodes |
1
set (6pcs) |
1 |
100172 |
|
|
| Boiler
Connection set |
| Product |
Dim |
Qot |
Art.no |
| Pump |
3x440V
60Hz |
1 |
100037 |
| Startpanel |
3x440V
60Hz 0,65A |
1 |
100115 |
|
| |
|
|
| |
|
|
| |
| iConnection
(Illustration 260a) |
|
|
|
|
|
|
|
